- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-27-2013 08:42 AM - edited 03-18-2019 02:21 AM
Hello!
Could you please help me... Is there a command or way to reduce the timeout of pairing between TC and SX-20, because when restart the both devices, it takes around 2minutes for pairing.
I'll appreciate your help, Regards
Solved! Go to Solution.
- Labels:
-
Room Endpoints
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-01-2014 07:00 PM
Hi,
There is no user available command to configure the pairing timeout. The touch will keep trying to pair with the previously known codec until succesfully paired or until you intervene and try to paired to other codecs.
Regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-01-2014 07:00 PM
Hi,
There is no user available command to configure the pairing timeout. The touch will keep trying to pair with the previously known codec until succesfully paired or until you intervene and try to paired to other codecs.
Regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-03-2014 08:35 AM
I appreciate your time and help, Thank you!
Regards.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-16-2014 12:51 PM
dont know if it reduces time in your case - but do you have static IP's assigned to both the SX20 and the Touchpanel? if either has DHCP then i presume completing the pairing process could take longer
