07-23-2012 11:15 AM - edited 03-17-2019 11:30 PM
WIth the latest software upgrade to TC 5.1.3 I have a locations where their network is retricted to one MAC address per port. Since the software upgrade the EX60/90 is broadcasting two MAC addresses per port; one for the codec and one for the touch panel. Is there a software change to prevent the touch panel MAC address from being broadcasted?
Solved! Go to Solution.
07-23-2012 11:24 AM
Hello,
I think you are running into following ddts :
Will be fixed in TE/TC release 6.0.0. Is not backported to TC5 release(s). Perhaps that should be done, the backporting?
07-23-2012 11:24 AM
Hello,
I think you are running into following ddts :
Will be fixed in TE/TC release 6.0.0. Is not backported to TC5 release(s). Perhaps that should be done, the backporting?
07-23-2012 11:39 AM
Thanks for your prompt response.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide