VCS Configuration Start

[n.shuja]

Hi,

I am to start a VCS implementation at our office setup.

Got VCS X7.1 MCU 4505 4.3(1.68) & CUCM 8.6.2

To start with i got 2 x MX300 and 1 x MX200 unit.

on CUCM th eend points work fine as 2way. How to verify that i have enough licenses for the VCS and MCU to start configuration. as the VCS overview gives the following output. As all the setup is on LAN/WAN no firewall involved do i need these licenses?

Non-traversal call licenses	Current	0
	Peak	0
	Since last restart	0
	License limit	0
Traversal call licenses	Current	0
	Peak	0
	Since last restart	0
	License limit	0
Registration licenses	Current	1
	Peak	1
	Since last restart	2
	License limit	2500

[Jens Didriksen · Accepted solution]

The VCS-C should come with 10 non-traversal and 100 traversal licenses, unless things have changed since we bought ours...

You'll need both; non-traversal for h323<-->h323 or sip<--->sip calls within the organisation, and traversal licenses for interworking h323<--->sip and IPv4<--->IPv6 calls within the organisation.

/jens

[n.shuja]

Thanks. verified, since this was a demo unit. no licenses were added instead a started pack was supplied.