cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
257
Views
0
Helpful
2
Replies
Highlighted

Touch 10 communication with crestron

Can anybody let me know how to use Cisco SX80 and touch 10 communication with Crestron 3 series control processor. I am already done with cisco in room control preparing the required GUI and loading it in Touch Panel, is there any further programming required in Cisco.

 

2 REPLIES 2
Highlighted
Cisco Employee

Re: Touch 10 communication with crestron

Hello,

 

Please refer the below link-

https://www.cisco.com/c/dam/en/us/td/docs/telepresence/endpoint/ce96/sx-mx-dx-room-kit-customization-guide-ce96.pdf

 

Thanks

 

Please rate if it is helpful...

Highlighted
VIP Advisor

Re: Touch 10 communication with crestron


@rjrahuljain0106 wrote:

Can anybody let me know how to use Cisco SX80 and touch 10 communication with Crestron 3 series control processor. I am already done with cisco in room control preparing the required GUI and loading it in Touch Panel, is there any further programming required in Cisco.

 


This appears to the be same question you asked in another post, just with a different title (https://community.cisco.com/t5/telepresence-and-video/touch-10-communication-with-crestron/m-p/3785296)- perhaps you can remove whichever one is not correct, or rephrase your question(s) to more appropriately describe the issue you are having.

But, despite that, if you are wanting to use the Crestron with the SX80 and In-Room Control, most of your programming effort will be on the Crestron side and getting it to react to the xevents and widgets.  Not much needs to be done on the Cisco end once you have your In-Room Controls set up and functioning on the Touch10.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.