cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Cisco Community Designated VIP Class of 2020

1977
Views
3
Helpful
2
Replies
Highlighted
Contributor

VCS control H323 call log shows no route to destination

I am placing a call from a C60 which is registered to a VCSc. The call is rejected and it says:

H323 <-> H323No route to destination Unreachable destinationVCS

If I place a SIP call to the same destination it works. The call search history also shows

H323 (Setup) No route to destination - Unreachable destination

H323 (ARQ) Found

Any help would be greatly appreciated and I always give good points for good help.

Thanks,

Alex

Everyone's tags (4)
2 REPLIES 2
Collaborator

VCS control H323 call log shows no route to destination

You need to give us a bit more information; i.e. is this to another end-point registered to the same VCS-C or to an external end-point? Does it only happen when you call that particular end-point? Is there a firewall in the picture?

/jens

Please rate replies and mark question(s) as "answered" if applicable.

Please rate replies and mark question(s) as "answered" if applicable.
Contributor

VCS control H323 call log shows no route to destination

I looked at the VCSe and the IP configuration was configured for NAT.  I took the NAT configuration out and that worked for my particular setup.  The configuration guide was very helpful.

Thanks,

Alex

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here