Hi
l have just bought an AIM-CUE for my cisco router 2801, which l have installed into the router but the service-engine is not showing up. l want to use the lab for hands on.
Router#sh ver
Cisco IOS Software, 2801 Software (C2801-ADVIPSERVICESK9-M), Version 12.4(15)T14, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2010 by Cisco Systems, Inc.
Compiled Tue 17-Aug-10 10:20 by prod_rel_team
ROM: System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)
Router uptime is 8 minutes
System returned to ROM by power-on
System image file is "flash:c2801-advipservicesk9-mz.124-15.T14.bin"
Cisco 2801 (revision 7.0) with 119808K/11264K bytes of memory.
Processor board ID FCZ1218949N
2 FastEthernet interfaces
3 Serial(sync/async) interfaces
1 Virtual Private Network (VPN) Module
4 Voice FXS interfaces
DRAM configuration is 64 bits wide with parity disabled.
191K bytes of NVRAM.
62720K bytes of ATA CompactFlash (Read/Write)
Configuration register is 0x2102
Router#sh diag
Slot 0:
C2801 2FE 4SLOT Mainboard Port adapter, 12 ports
Port adapter is analyzed
Port adapter insertion time unknown
EEPROM contents at hardware discovery:
Chassis MAC Address : 001f.ca07.a658
MAC Address block size : 34
PCB Serial Number : FOC1213159H
Hardware Revision : 7.0
Part Number : 73-8190-07
Board Revision : C0
Top Assy. Part Number : 800-23435-05
Deviation Number : 0
Fab Version : 04
CLEI Code : IPM7V00CRA
RMA Test History : 00
RMA Number : 0-0-0-0
RMA History : 00
Product (FRU) Number : CISCO2801
Version Identifier : V04
Processor type : 86
Chassis Serial Number : FCZ1218949N
EEPROM format version 4
EEPROM contents (hex):
0x00: 04 FF C3 06 00 1F CA 07 A6 58 43 00 22 C1 8B 46
0x10: 4F 43 31 32 31 33 31 35 39 48 40 04 1C 41 07 00
0x20: 82 49 1F FE 07 42 43 30 C0 46 03 20 00 5B 8B 05
VIC Slot 0:
FXS DID Voice daughter card (4 port)
Hardware Revision : 3.1
Part Number : 73-6918-02
Board Revision : F0
Deviation Number : 0
Fab Version : 02
PCB Serial Number : FOC1233057M
RMA Test History : 00
RMA Number : 0-0-0-0
RMA History : 00
Top Assy. Part Number : 800-17016-02
Connector Type : 01
CLEI Code : IP9IABYCAA
Product (FRU) Number : VIC-4FXS/DID=
EEPROM format version 4
EEPROM contents (hex):
0x00: 04 FF 40 00 3A 41 03 01 82 49 1B 06 02 42 46 30
0x10: 88 00 00 00 00 02 02 C1 8B 46 4F 43 31 32 33 33
0x20: 30 35 37 4D 03 00 81 00 00 00 00 04 00 C0 46 03
WIC/VIC/HWIC Slot 1:
Serial 1T WAN daughter card
Hardware revision 1.0 Board revision D0
Serial number 36399297 Part number 800-01514-02
FRU Part Number WIC-1T=
Test history 0x0 RMA number 00-00-00
Connector type Wan Module
EEPROM format version 1
EEPROM contents (hex):
0x20: 01 02 01 00 02 2B 68 C1 50 05 EA 02 00 00 00 00
0x30: 68 00 00 00 08 03 28 01 FF FF FF FF FF FF FF FF
WIC/VIC Slot 2:
Serial 1T WAN daughter card
Hardware revision 1.0 Board revision D0
Serial number 36242801 Part number 800-01514-02
FRU Part Number WIC-1T=
Test history 0x0 RMA number 00-00-00
Connector type Wan Module
EEPROM format version 1
EEPROM contents (hex):
0x20: 01 02 01 00 02 29 05 71 50 05 EA 02 00 00 00 00
0x30: 68 00 00 00 08 01 10 01 FF FF FF FF FF FF FF FF
WIC/VIC/HWIC Slot 3:
Serial 1T WAN daughter card
Hardware revision 1.0 Board revision L0
Serial number 25666361 Part number 800-01514-01
FRU Part Number WIC-1T=
Test history 0x0 RMA number 00-00-00
Connector type Wan Module
EEPROM format version 1
EEPROM contents (hex):
0x20: 01 02 01 00 01 87 A3 39 50 05 EA 01 00 00 00 00
0x30: A8 00 00 00 01 09 01 01 FF FF FF FF FF FF FF FF
outer#sh run
Building configuration...
Current configuration : 938 bytes
!
version 12.4
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname Router
!
boot-start-marker
boot-end-marker
!
no aaa new-model
dot11 syslog
ip cef
!
multilink bundle-name authenticated
!
voice-card 0
!
archive
log config
hidekeys
!
interface FastEthernet0/0
no ip address
shutdown
duplex auto
speed auto
!
interface FastEthernet0/1
no ip address
shutdown
duplex auto
speed auto
!
interface Serial0/1/0
no ip address
shutdown
no fair-queue
clock rate 2000000
!
interface Serial0/2/0
no ip address
shutdown
clock rate 2000000
!
interface Serial0/3/0
no ip address
shutdown
clock rate 2000000
!
control-plane
!
line con 0
line aux 0
line vty 0 4
login
!
scheduler allocate 20000 1000
end
Router#s?
*s=show send set setup
show slip ssh start-chat
systat
