Cisco ATA 191 not registering on cucm

[akram.root]

Hello ,

I have a ATA 191 registered already on cucm 11.5 all work fine but after this ATA not registering on cucm , i had reset it and reconfigure it 

but not success , it give me his addrress IP and i can enter to it by browser and i can't modified anything ,just reading his configuration parameters , when i check the logs i found this:

local1.err Telephony: CUCM ERROR!!! [cucm_load_info: 285(tick=0x0)]load domain name fails

ATA191 local1.err Telephony: CUCM ERROR!!! [cucm_load_info: 304(tick=0x0)]load tftp address fails

Could you help me to redister this ATA on CUCM again ?

Best regards 

[Roger Kallberg]

Correct.

[MrButton]

Do you have any ATAs registered in CUCM?  If yes do a settings comparison.  If everything looks good in the profile and Device security Profile under Protocol Specific Information make sure your DHCP is sending OPTION 150 with the TFTP server addresses.  

[akram.root]

Thank you for your reply,

 Do you have any ATAs registered in CUCM? Yes , i had alreday do a settings comparaison ,all have the same configuration.

My DHCP is sending correcttely the option 150 with the  tftp server address.

[akram.root · Accepted solution]

The problem is solved after configure  TFTP server address manually via IVR.

For IVR, hit ****
Enter password, default is 24726
Enter option 221 to configure TFTP server IP address

Best regards