Cisco Mobile 8.0 for iPhone

[Paolo Bratti]

Hello,

I need to explain to my customer interoperability between CUCM and Apple iPhone, Nokia E52, SIP Third-party device ...

I configured "Dual-mode phone for iPhone" device in my CUCM company, and it works very well!

I installed a new DEMO CUCM, but "Dual-mode phone for iPhone" device doesn't work! When I try to connect my iPhone to new DEMO CUCM, device gives me this error: "Failed to register with the supplied information".

In the new DEMO CUCM, i have only configure  Device Pool, Partition, CSS ... below, in attach, you can find my "Dual-mode phone for iPhone" device on new DEMO CUCM configuration.

Any ideas?

Thank you!

[htluo · Accepted solution]

Go to CUCM > System > Servers.

Are you using hostname or IP address there?  If your iPhone cannot resolve the hostname there, you should change the hostname to IP address (on CUCM).

Michael

http://htluo.blogspot.com

[Paolo Bratti]

OK,

it works!

Thank you!

[BILL KEMPTHORNE]

This was driving me a little nuts in our test lab ... no FQDN on the CUCM service, changed to IP - works fine.

Thanks...

[KY_]

Do I need a lincence  this services, Ih we need a licence how can add licence the system,