03-26-2012 05:54 AM - edited 03-19-2019 04:39 AM
Hi All
I am trying to install a Cisco UCCX, once i entered IP Address, subnet mask and GW address and when it try to connect the server it cannot be able to reach the network. All the IP address ,subnet mask and GW address are valid.
We using a Cisco C200 M2 server and the port are connected to right VLAN. We do have two VLAN which one is server VLAN and another is Voice VLAN. The CIMC port and one of the LAN port are on server VLAN and other port is Voice VLAN. The UCCX server we giving the ip range in voice vlan.
I also created a Virtual Machine port group and specifed the VLAN number and before installing it is assigned to the server in VSphere Client. Still while installing the issue is same.
Is there anything i need to do on CIMC or is there anything else i need to do. Please guide me on this issue.
Regards
Prasanth Thomas
Solved! Go to Solution.
03-26-2012 06:32 AM
Your standard virtual switch must be wrong, you'll need to fix that in VMware if ou expect any of the VMs you create to connect to your networks. This might also be a problem with your actual switch where UCS is connected.
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
03-26-2012 06:32 AM
Your standard virtual switch must be wrong, you'll need to fix that in VMware if ou expect any of the VMs you create to connect to your networks. This might also be a problem with your actual switch where UCS is connected.
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
03-26-2012 07:15 AM
Thanks for the quick reply :-)
Can you guide me how to fix the virtual switch in VMWare network. I guess we dont have any issue on switch side since the same switch is used for another 2 UCS server and it works fine with the same.
I attached the VSphere Client image. Coudl you please let me know if this is the right way to do
As i said We do have two VLAN
VLAN 11 - Server VLAN
VLAN 98 - Voice VLAN
CIMC and 1 port is in VLAN 11 (Server VLAN)
2nd Port is in VLAN 98 (Voice VLAN)
The server we installing UCCX will be on voice vlan
03-26-2012 07:20 AM
Change the network from the VM, from what you're telling is should be on vSwitch1 and not vSwitch0.
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
03-26-2012 08:16 AM
Thanks for the reply.
I made the changes as you mentioned and again installed and still am facing the same issue. Below is the is screenshot which the error showing while installing.
And the change which I made on VMWare is
Regards
Prasanth Thomas Abraham
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide