Cisco Unified CM Administration

[cmabindla]

Good day, I just want to know how can i re-enable CDR output on the CISCO CM switch

Regards 

CHUMA

[Brandon Buffin]

In CUCM, enable CDR by going to System > Service Parameters > Callmanager service > set CDR Enabled flag to True.

Brandon

[cmabindla]

Thank you very much Brandon

Regards

CHUMA

[Jaime Valencia]

Bear in mind that such setting is a server setting, if you have more than one server in your cluster, you need to enable it on every server that is handling calls.