CUCM Bulk Admin>Update Phone task, not working.
I use to update Endpoint firmware/software.
I was using it last week (last used on 5th April to run a job on 7th April) successfully.
When I set the target endpoints in Find then click Next to fill up Device Load information, ticked Apply Config.
Then click on Submit. No response or nothing happens during Submit. But Back button works.
Checked the Job Scheduler, there is nothing created.
Checked Servicibility, seems all active services are running.
What else should I check?
Go to Solution.
Tried to restarting the Bulk Provisioning Service, didn't fix it.
Seems number of jobs in Job Scheduler were 200+. So archived few of the oldest jobs then started to work. I can now create new task/job and schedule it successfully.
View solution in original post
Try with restarting the Bulk service on the publisher and then create the task again.
As @Roger Kallberg mentioned, restart the BPS.
The Control Center–Feature Services window displays.
Cisco Bulk Provisioning Service displays in list under Service Name column, in the Database and Admin Services area.
If BPS is already activated, the Activation Status will display as Activated.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: