I have setup a trunk group for my (4) FXO ports. The ports are all setup with "connection plar 2000" since all calls need to route to a parallel huntgroup of which the pilot is 2000. If I cann one of the POTS lines in the group and do not pick it up, the call goes to a busy signal after about 3 rings. I have final destination set to a script. Not sure on why I am getting the busy signal.
If stack up the calls on all phones the hunt group, the nex tell will route to the script just fine and not give a busy signal. Not sure if that gives any clues to my issue or not.
TIA, Jim
