02-15-2012 05:18 AM - edited 03-19-2019 04:24 AM
Any help on how to setup the following scenario
CUCM---H323gateway(3925)---H323gateway (Vg204)
The problem in configuration on the 3925 to act as H323 to server CUCM and server Vg204 at the same time .
Thanks
02-15-2012 05:28 AM
Hi
I'm not quite sure what you are asking here - but typically with a CUCM system the two VGs should not communicate directly. You would have dial-peers covering all internal numbers on each, pointing at the CUCM servers, and the CUCM servers would route to the gateways using route patterns.
If a call needs to go from 3925 --> VG204 then it would go:
3925--> Dial Peer --> CUCM Serer --> Route Pattern (and optionally Route List/Group) --> VG204
If you configure the H323 gateways to send calls directly to each other this bypasses things like CDR on CUCM, and decentralises the admin of your dial plan.
Regards
Principal Engineer at Logicalis UK
Please rate helpful posts...
02-15-2012 05:55 AM
Thanks you Aaron , but my question is how to setup the 3925 router to be H323 gateway for the CUCM call manager and to be as H323 for VG204 as well , so call from > IP phone --- CUCM --- 3925 ---VG204---analogue phone and vise versa
the VG204 is directly connected to only 3925 router , and the 3925 connected to both CUCM and VG204
Thanks again
02-15-2012 06:14 AM
Hi
If you really want to configure them to send H323 calls direct to between the 3925 adn VG204, then you would configure dial-peers on each with appropriate destination-pattern set, and 'session target ipv4:x.x.x.x' set to the other device.
Bear in mind that if you don't have full IP reachability between the VG204 and all the devices associated with the CUCM that it might call, then you will probably get some problems. If you have full reachability I would configure each device to route calls between only itself and CUCM as suggested above.
Regards
Aaron
02-16-2012 01:17 AM
But when I try to configure the interface on the 3925 which is connected to the VG204 as H323 , it gives me error message (duplicate media ) , here is the question :
3925 G0/0 is configuered as H323 and it is conected to the network where I have CUCM
G0/1 is directly connected to the VG204 ( I want to configure this interface as H323 as well , but cant due to error message (duplicate media )
Is there solution ?
02-16-2012 07:23 AM
Any particular reason why you cannot just plug the VG204 into a switch to avoid this setup??
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide