Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
621
Views
0
Helpful
2
Replies

Incoming UDP is not working for Natted IP

chaman prakash
Level 1
Level 1

‎05-27-2019 04:07 AM

Hi All,

I have Natted IP address from 192.168.X.X to X.X.X.X . when the call is going out over SIP Trunk, outgoing call is working fine. But for the incoming call . Its giving no way audio. 

Please help me to confirm if there is a way to allow incoming UDP traffic to allow over Natted IP 

Labels:
0 Helpful
2 Replies 2

Jonathan Schulenberg
Hall of Fame
Hall of Fame

‎05-27-2019 06:41 AM

The NAT device would need to support application-later payload inspection to rewrite IP and port information within the packet.
0 Helpful

chaman prakash
Level 1
Level 1
In response to Jonathan Schulenberg

‎05-27-2019 06:58 AM - edited ‎05-27-2019 07:01 AM

@Jonathan Schulenberg :Thanks for your revert
Please help with any document or any reference link to go through.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents