Inter-Cluster Trunk

[Jayesh Prajapati]

i have two cluster and i am doing (Non-Gatekeeper Controlled) ICT. but it's not working.

i do setting like :

Product:Inter-Cluster Trunk (Non-Gatekeeper Controlled)

Device Name:my sever name

Tunneled Protocol:none

Inbound Calls

Significant Digits: All

Outbound Calls

Calling Party Selection:originator

Remote Cisco Unified CallManager Information

Server 1 IP Address/Host Name:my other cluster ip add

but i can't call one cluster to other cluster...???

[Zin.Karzazi]

Hi,

First you need to set up a route pattern to your remote site. Let s say your DNs are 7xxx and your remote site is using 6xxx.

set up a route pattern 6xxx and select the trunk Route List in it.

1- Include the Partition of your Route pattern (6xxx) in the CSS of your phones.

2- See if there is any pre dot or anything related in your Route pattern

3- Ensure that the route list on your RP is correct (ie Trunk Route List)

4- on your remote trunk-> Inbound call -> CSS

check if this css include the Partition of your phones.

if all this doesnt help. use Dialed Number Analyzer (https://ip/dna) select trunk and see what the results are. Activate Traces on both callmanager (SDI, SDL). Use a sniffer on your phone and see if he is sending packets to your remote CCM.

HTH

Zin Elabidine Karzazi

[Rob Huffman]

Hi Zin,

Very nice answer! 5 points for your good work.

Take care,

Rob

[nagabhushanamj]

Hi,

I have one doublt on ICT.

In my network I'm going to create one ICT between CCM4.x cluster & CCM6.x cluster. Is it work or not. since i have doubt that ICT will work between same version of CCM cluster. Please correct me..

Regards

Naga.

[kumaran.samikkannu]

Hi Naga

I have tested the ICT between CM4 and CM5 and between CM4 and CM6, it should work without any issues

Thanks

Kumaran

[nagabhushanamj]

Hi Kumaran,

Thanks for your reply. Once I test i will give the feedback

Naga