cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2476
Views
5
Helpful
4
Replies

ISM CUE Corrupted netboot image detected

prasanth_k
Level 1
Level 1

HI,

I am trying to install Unity express 8.6 on ISM-SRE but getting an error saying that "

Corrupted netboot image  detected"

Any one faced this issue ? The network connectivity is ok. I can ping TFTP and FTP.

ServicesEngine boot-loader> config                                            

IP Address [10.64.5.6] >                                                      

Subnet mask [255.255.255.0] >                                                 

TFTP server [10.64.13.3] >                                                    

Gateway [10.64.5.1] >                                                         

Default Helper-file [cue-installer.SPA.sme.8.6.6] >                           

Default Boot [none|disk] [disk] >disk                                         

Default bootloader [primary|secondary] [primary] >primary                     

Updating flash with bootloader configuration.

Please wait .............. done.

ServicesEngine boot-loader> boot helper                                       

Loading tftp://10.64.13.3/cue-installer.SPA.sme.8.6.6 ... done.

Verifying ...

Corrupted netboot image  detected

done.

Starting Kernel.

Thanks

4 Replies 4

clileikis
Level 7
Level 7

Hi there,

Have you tried the service-module install url method, ex:

service-module sm 0/0 install url ftp://username:password@128.107.146.189/dir/cue-vm- k9.sme.7.1.2.pkg script cue-vm- k9.sme.7.1.2.sre

http://www.cisco.com/en/US/docs/voice_ip_comm/unity_exp/rel8_6/install/installsre.html#wp1129275

HTH,

Chris

Dude, this totally worked... I was trying dozens of different versions of code on an SRE-300 and every time, corrupted netboot image... did the service-module install and it worked like a champ!

 

Thanks!

Thai Huynh
Level 1
Level 1

Hi

  points

prasanth_k

prasanth_k

I had the same problem, did you figure out how to fix it yet? please share as I'm spend days without any luck.

Thanks in adv.

caparis
Cisco Employee
Cisco Employee

Hello ...

in my case... I use the version 8.0.5 first with boothelper and work, but in a moment before, when I tried to do it with the process described in another answer, I can do it but I forgot the language package, and the installation give an error... in that moment I didn't associate the error to the language package file but when I use the boot helper the error is more specific and I download the language file and finish the instalation with 8.0.5 and after that with the service-module process I upgrade to 8.6.6

Regards