Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone, I have a problem with my UC540, below is my network diagram: Internet---------887----------UC540 I have successfully configured UC540, incoming and outgoing call working perfect, but when I changed IP address on UC540's F0/0 which connec...
Hi everyone, I have a problem with my UC540, below is my network diagram: Internet---------887----------UC540 I have successfully configured UC540, incoming and outgoing call working perfect, but when I changed IP address on UC540's F0/0 which connec...
Hi everyone...I have configure login block 1/2hr if anyone enter wrong password 3 times (cml), also I have applied quite-mode for local SSH (ACL applied), after the router block all incoming telnet or SSH from outside (WAN), I can access to the route...
Hi everyone, I have 2 Cisco router connected via Serial cable, Router1 is an ADSL gateway, Router2 connected to Router1 via serial cable, all the hosts of Router2 can ping and access to Internet website through Router1, but I can't ping an internet a...
Hi everyone,I'm new with CME and I'm have a problem to make a call from SCCP to SIP phone, SIP phone registered fine under Voice Register Global, I can make the call from SIP to SCCP and working perfectly, example: SIP(ext 2001) dial 1002 ---> SCCP(1...
Hi, I have the same problem and I fixed it with your method, but then the second sip account stop working after a few hours, please advive how to make it work. Thanks in advance.
