Mobile voice access

[ermionline]

Hi I am using cucm9.1, i want to configure mobile voice access.

These are the scenarios,

1, My internal DN scheme is like XXX

2, My Head number or Gateway number is 8090(Accesible from PSTN)

3, I have already configured Remote destinations for the users

4, When external call come to 8090, first it will be routed to system call handler

But i have no idea what number should i use for MVA DID. does it has to be like xxx or something else?

[Suresh Hudda]

You can follow below doc, if you get stuck somewhere then pls post here back.

http://bhatkoti.com/2010/01/02/how-to-configure-mobile-voice-access-mva-in-cisco-cucm-6-x7x/

Suresh

[ermionline]

I follow the link but......Error 404

Page not found

[Terry Cheema]

The number can be any number, that you can call for outside or in other words it should be a DID number.

Follow below link whichever you like for config steps:

http://duzceli1979.blogspot.com.au/2013/04/mobile-voice-access-mva-configuration.html?m=1

http://pandaeatsbamboo.blogspot.com.au/2012/02/mobile-voice-access-mobile-connect-step.html?m=1

Terry

Please rate all helpful posts

[ermionline]

Thank you Terry for you reply

Okay I assigned 111 for my MVA, but  i can`t call 111 from my remote destination or any other PSTN. So what do i have to do to call to 111. do i have to first dial 8090(my gateway number) then press111.

Please help am confused Here...............Thanks!!!!!!!!!!!

Ermias W

[Terry Cheema]

MVA number should be reachable from outside - it should be one of your DID/DDI/ or main number as you say.

-Terry

[ermionline]

Tnx man!!!!!!!!! That`s what i want to know

[Terry Cheema]

No Worries and don't forget to rate all helpful posts and mark thread as answered if you have no other queries.

-Terry