Hi everyone, i woul like to request your help to solve this.
I´ve a 2811 router with CME 7.1 and CUE 8.5. >>>
Cisco 2811 (revision 53.51) with 245760K/16384K bytes of memory.
Processor board ID FTX1221A3CJ
2 FastEthernet interfaces
1 terminal line
1 Virtual Private Network (VPN) Module
8 Voice FXO interfaces
1 cisco Internal Service Module(s)
Cisco Unity Express 8.5.1 in slot 0
DRAM configuration is 64 bits wide with parity enabled.
239K bytes of non-volatile configuration memory.
250880K bytes of ATA CompactFlash (Read/Write)
I´ve done the basic config for CUE
interface Internal-Service-Module0/0
ip unnumbered Loopback200
service-module ip address 10.200.1.10 255.255.255.0
!Application: CUE Running on AIM2
service-module ip default-gateway 10.200.1.1
hold-queue 512 out
telephony-service
...... Partial config output
voicemail 9000
max-conferences 8 gain -6
moh music-on-hold.au
multicast moh 239.1.1.10 port 2020
web admin system name AdminGL secret 5 $1$cO2U$obekJlX4reI3MzIQHeg4h.
dn-webedit
time-webedit
transfer-system full-consult
secondary-dialtone 9
create cnf-files version-stamp 7960 Jun 14 2011 15:36:57
I´ve also created the dial-peers for CUE. The problem is that when i run the CUE wizard it tells the it could not find user from CME, but i have my user created under ephone-dn config. So i don´t know why is this happening, could someone help me?. Thanks.
!
