01-11-2010 08:51 AM - edited 03-19-2019 12:15 AM
Does anyone know if there is a built in report to view the "state" of a device (on, off, etc.)? Or if there is a way, going forward, to monitor particular devices? Thanks!
01-11-2010 10:33 AM
No report on phones on/off, but if you search the devices you'll see them registered/unregistered.
That's as close as you can get with CUCM.
You would need to elaborate on "monitor particular devices".
AC can monitor the line status, you can also use BLF/SD to monitor lines.
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
01-11-2010 12:29 PM
As far as monitoring ... I wasn't sure if there was a way to be notified if a particular phone is shut off?? I have wireless phone users who "disappear" and become unreachable.
02-12-2010 01:30 PM
Not natively in CUCM. You would need to look into either a 3rd party network management product or developing a solution in-house. Since you are looking for a trigger event equal to a specific phone station (or set of stations) then you would be looking at a management solution which could consume, parse, and create an alertable event based on either a SNMP trap or a syslog message from the CUCM cluster.
Each time a device unregisters, an event is recorded in the local Application syslog and sent to a remote syslog or SNMP trap receivers assuming you have configured CUCM to do so.
Please remember to rate helpful responses and identify
02-12-2010 07:41 AM
I guess there are a number of reporting tools that might give you what you are looking for. I use 1 from
DominoComms (www.dominocomms.com) that gives some really cool reports, pretty sure it gives active / non-active too which is what you are looking for. I think its limited deployment but there is a request button to get a copy. Give it a go to see if it helps.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide