03-17-2010 11:16 AM - edited 03-19-2019 12:38 AM
I have FXS ports configured with STCAPP so the ports registers with CME and use SCCP features, but the device name, used as the MAC address to register the port on ephone, changes when the router resets and the ports are unregistered. Is there a way so the device name used as the MAC, always be the same??
Thanks,
Juan Carlos Arias
Solved! Go to Solution.
03-17-2010 11:20 AM
Hi
Make sure you bind it to a specific, real LAN interface - it should always use that MAC address then:
sccp ccm group 1 bind interface FastEthernet0/0
Regards
Aaron
Please rate helpful posts...
03-17-2010 11:20 AM
Hi
Make sure you bind it to a specific, real LAN interface - it should always use that MAC address then:
sccp ccm group 1 bind interface FastEthernet0/0
Regards
Aaron
Please rate helpful posts...
03-17-2010 11:34 AM
Aaron, thanks for your answer, I review that configuration and I have to make it right, thanks for your time.
Regards,
Juan Carlos Arias
03-18-2010 09:25 AM
Aaron, I made some changes last night but I have a issue to solve, is a router UC520 which actually is configured stcapp with interface BVI
sccp ccm group 22
bind interface BVI10
but as you now, UC520 has only one physical interface which is configured to Internet connection, all others interfaces are virtual and don't have an IP address assign it, I tried with interface VLAN too, what do you recommend?? Configure a sub-interface with internal address?
Regards,
Juan Carlos Arias
03-18-2010 09:54 AM
Hi there
If you are binding to a BVI, the default is that it will generate a MAC address at startup.
Try:
Conf t
Int bvi10
Mac-add 0000.0c43.4343
Then do:
Show int bvi10 | i address
See if that MAC address then stays the same after a reboot
Regards
Aaron
Please rate helpful posts...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide