cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
294
Views
0
Helpful
2
Replies

Unity 3.1.5 - CSCdy52087

adignan
Level 8
Level 8

If you look up this bug it says it is fixed in version 3.1(5.63)

"If the Directory Synchronization process between Unity and Exchange fails

there may not be any errors logged of the failure in the Event log.

Additionally, if the synchronization failure was due to incomplete/inaccurate

information in Exchange, then the same failure may happen again during the

next synchronization cycle.

The only symptom that may manifest itself may be higher than normal CPU utilization

(especially during the replication intervals--every 10 minutes for Exchange 5.5)."

Fixed in 4.0(1.19), 4.0(0.265), 3.1(5.63)

I would much rather apply an ES to fix the problem at this point, rather than having to upgrade but not sure how to get to 3.1(5.63)

2 Replies 2

lindborg
Cisco Employee
Cisco Employee

You'll need to upgrade to 3.1(6) at least - I don't believe there is an ES for 3.1(5) for this issue (the ES number would have been posted in the release notes if there were in most cases).

Hin Lee
Cisco Employee
Cisco Employee

I checked the list of Engineering specials available for 3.x and there is not one available.

H. M.