Unity Connection 8.5 Unified Messaging MWI

[juan.anzola]

Hi Guys,

     I just configured Unity Connection 8.5 Single Inbox with Exchange 2007. Everything is working fine, except the MWI goes off as soon as the Exchange gets the message. Is this the expected behaviour?

     I need that the MWI stays ON until the user reads the message in Outlook. Is that possible?

Thanks! 

[phamvinhdat]

Is the message stay in Inbox or is it set to move to certain folder. If the message is being touched in email, MWI will be off.

[juan.anzola]

It stays in inbox. as a new message.

[marks]

Iam having same issue

Sent from Cisco Technical Support iPhone App

[Tray Stoutmeyer]

Not sure if it applies here but, if you aren't moving it to another folder in your Outlook, try looking at this....

https://supportforums.cisco.com/community/netpro/collaboration-voice-video/unified-comm-application/blog/2011/03/02/cisco-unity-exchange-2007-disclaimer-transport-rule-causes-mwi-to-fail

Let me know if you have a disclaimer setup on Exchange 2007 etc.

Thanks!

Tray

[juan.anzola]

Hi Tray!

   The MWI tunr on when the message is left, but as soon as the unity delivers it to Exchange, the MWI goes OFF. Is that the expected behaviour?

[Tray Stoutmeyer]

It's only expected if like previous posters have said, it is moved to another folder than inbox by a rule or marked read by someone. This is why I sent the link. Did you check for that?

Thanks!

Tray