polycom ip7000 on uc540

[Innovation Networks]

I have a uc540 and a polycom ip7000 from a previous system. What would be best way to get it to work on my uc540?

Thanks for your help.

[paolo bevilacqua]

Configure as third-pary SIP phone. There are multiple threads on the subject.

[steven1066]

I have the same requirement but I was unable to locate any specific thread that deatils how to add a third-party SIP phone.

I did attempt to configure the ephone-dn and ephone, but was not successful in adding the command dtmf-relay sip-notify to the ephone, and I cannot figure out why, but then is this correct programming?

Here are my commands:

ephone-dn 127

  number 7927

  pickup-group 1

  label 7927

  description 0123456789

  name Polycom Conf Phone

ephone 17

  device-security-mode none

  mac-address 0004.F2ED.973E

  username "EXT7927" password EXT7927

So any assistance in this matter is greatly appreciated.

Thanks,

Steven

[kifayat_Ullah]

Has any body made it working, i am in the sitatuon. I have connected my polycom to the FXS port and it is working but for one way call only. i cant make two calls or call a third party.

please advise