a SP boots to BIOS gui interface ?

[delahais]

I just created and associated a new SP to a B200M3.

When i check the boot server via the vConsole, i can see that the B200 switch to BIOS "gui interface". If i try to go out the bios, the B200M3 switch back to bios.... in short, i can not leave the bios GUI intercace.

I do not configure any bios policy (so = default)
The B200M3 is less local disk ; the SP must boot on SAN

Any ideas are welcome

BR

[Manuel Velasco · Accepted solution]

Hi Delahais,

In the service profile, did you assigned a boot order policy?  If you don't have a boot order with CD/DVD and local or remote store the blade will always go to the BIOS screen.

Also did you confirm what the association was completed 100%?

[delahais]

The zoning was ko, so the B200M3 did not see any LUN (no local disk)

Many thank

Nicolas.

 PS : previously, I do remember the B-serveur does not go to bios... it just returned an error message.... more explicite.