- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-06-2021 11:04 PM
Iscsi boot
VMware
We added a new B200 M5 blade(blade5/slot5) with expander card to a B200 M5 only chassis with 3 existing B200 M5's(No expander cards-to be added after successfully adding the new blade in slot 5)
Current Errors adding the new blade are, Service Profile: no.19
F16995 : [FSM:STAGE:RETRY:]: Evaluate association with server (FSM-STAGE:sam:dme:LsServerConfigure:EvaluateAssociation)
F0689 : Assignment of service profile iscsi_xxxxxx19 to server failed
F0327 : Service profile iscsi_uwcpvw19 configuration failed due to compute-unavailable,insufficient-resources
I have done this twice : "blade re-ack should resolve the issue."
Any Advice to solve these issues would be appreciated.
Solved! Go to Solution.
- Labels:
-
Unified Computing System (UCS)
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-07-2021 05:35 AM
Is the blade showing fully discovered? If the blade does not discover the service profile will stay failed.
"compute-unavailable" typically indicates a server pool is in use on the service profile, but the physical server is not part of the server pool. Are you using server pools here to mange the blades?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-10-2021 10:11 AM
Adding 3/5 to the server pool(manually add) resulted in the "grab" of the available Service Profile "Service Profile: no.19" .No Errors after the change. Thank you @Wes Austin.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-07-2021 05:35 AM
Is the blade showing fully discovered? If the blade does not discover the service profile will stay failed.
"compute-unavailable" typically indicates a server pool is in use on the service profile, but the physical server is not part of the server pool. Are you using server pools here to mange the blades?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-07-2021 06:25 AM
Hi @Wes Austin,
I have attached the M5 in slot blade's status
You are correct, server pools are in use. The last 2 M5's added (slots6 and now slot5) are not in the server pool.Slot6 is however still functioning. We have 3 chassis (1 and 2 are M3's)(3 is the x M5's) 16 M3's and 2 m5's are in the server pool
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-10-2021 10:11 AM
Adding 3/5 to the server pool(manually add) resulted in the "grab" of the available Service Profile "Service Profile: no.19" .No Errors after the change. Thank you @Wes Austin.
