09-30-2013 01:38 PM - edited 03-01-2019 11:17 AM
A customer recently upgrade his C200 from 1.4(3l) to 1.4(3p)5. Upgrade went fine and the system is running properly, however, both the CIMC GUI and CLI report firmware version is 1.4(3p) (see below)
Is this an expected behavior? Is this known bug or limitation?
Is there any way to have evidence the firmware was updated to the correct version?
Should customer open a Service Request to investigate this further?
Thanks in advance.
Gabriel Tlalpachicatl
VCE Customer Advocate
09-30-2013 02:25 PM
Gabriel,
Before opening a case, can you provide the output for the following?
-A# scope chassis
-A/chassis# scope firmware <<< and from here a "show detail"
-Kenny
Cisco Support Community is also present in Spanish:
https://supportforums.cisco.com/community/spanish/data_center
10-01-2013 11:45 AM
Thank you Keny.
Here is the requested output
It should show 1.4(3p)5, shouldn´t it?
Is this a bug?
Thanks,
Gabriel
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide