Auto Install upgrade failure

[SDavidson15]

Hi Everyone,

The support forums have been a great help wanted to thank everyone for their input. I'm upgrading to 2.2(6) from 2.2(3d) and during the auto install I'm getting stuck at 65% on my Fabric Interconnect. I Tried to force it with manually but it will not work. Any suggestions?

Thanks

[Qiese Dides]

Hi S,

So you are most likely hitting this bug

https://tools.cisco.com/bugsearch/bug/CSCun79792/?reffering_site=dumpcr

Your /var/tmp folder is likely above 10% which is causing this pre-check to fail. You will have to open a TAC case for them to load our plugin which can clear this error. Let me know if you have any other questions.

Regards,

Qiese Dides

[Wes Austin]

Hello,

As Qiese suggested you may need to clear out that directory. If this is pre-production, you may opt to just reboot the FI that is stuck and it should clear the directory as well. I would still make sure you address the /var/tmp issue accordingly, however, the reboot will help to complete the upgrade.

--Wes

[Walter Dey]

see https://supportforums.cisco.com/discussion/12745436/upgrade-failure-223d-226d