Blades with mixture of ViC/CNA

[Kassim Ismail]

Hi All,

Is there is an issue if a UCS chassis 5108 has B200 blades with a mixture of CNA & ViC card? say some blades have M73KR & others have ViC1240.

would this work?

Thanks

Kass

[Manuel Velasco · Accepted solution]

Yes this is supported, you can verify this using the compatability matrix below http://www.cisco.com/web/techdoc/ucs/interoperability/matrix/matrix.html let me know if this answers your question

[Kassim Ismail]

Hi Manuel,

Thanks for the confirmation & the link. i will take a look at it.

Kass

[Manuel Velasco]

Sounds good, also note that what matters here is that the adapter is supported by the blade and the firmware that is running.

[Kassim Ismail]

i guess that it would be better to be on the same supported firmware level across all the blades.