01-18-2012 02:20 PM - edited 03-01-2019 10:14 AM
Hi all
How can I check if the RAID configuration in my C200 M2 server is correct, the server was purchased from Cisco and I understand that it should be preconfigured with the correct RAID for Call Manager but I want to double check and make sure before I install VMW and create the virtual machines, I went in to the pre-boot CLI and ran the command -ldinfo -l0 -a0 and got the following out put:
Does this mean is correct ?? not to familiar with this and not sure how to check if Primary 1 has disk 0, and 1 and Secondary has 2 and 3, do I need to reconfigure RAID to match the config. in the release notes
Thanks
01-18-2012 03:10 PM
Here is what your config should be.
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/virtual/servers.html#wp53962
01-18-2012 03:56 PM
Hi Reginald
Thanks for your replay but I know what my configuration should be, what I dont know is if the out put of the command displayed above is the result of a right configuration, since this was a tricky question I opened a TAC case and they confirmed that the C200 M2 purchased directly from Cisco comes preconfigured with RAID 10 and that the output indicates that is correctly configured.
Luis
01-18-2012 07:19 PM
Luis,
Glad TAC was able to get you an answer. I figure if it came from us(Cisco)then it would have the config you ordered. Thanks for being a customer.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide