04-03-2013 11:27 PM - edited 03-01-2019 10:57 AM
Hi,
Is CDP is enabled by default in UCS? If not then how we will enable it? While enabling the same in production setup will cause any impact on Network link or production?
Anandraj
04-04-2013 05:03 AM
Its not enabled by default. You can enable/disble it by assigning a "Network Control Policy" to the vNIC.
http://www.cisco.com/en/US/docs/unified_computing/ucs/sw/gui/config/guide/2.1/b_UCSM_GUI_Configuration_Guide_2_1_chapter_010101.html#d95479e4163a1635
Regards,
Robert
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community