Unified Computing System Discussions

I need to replace both IO modules (2104XP) in a chassis. Does any have the correct procedure to remove and replace a new IOM? Should I do the one attached to the secondary FI first? Do I need to failover the FI to replace the 2nd IOM or can I just sh...

                   Hi,I have the current setupUCS chassis (4 uplinks) --> FI --> (Port channel) --> N5K --> (port channel) --> VSS 6500I configure port channel between IO Module and the FI by changing to policy to "Port Channel" and set the link to 4...

Dear all:Document Cisco UCS Manager VM-FEX for Hyper-V GUI Configuration Guide, Release 2.1.pdf say install vmfex_tools-xxx.msi can config port profile,But I can not find this file.Have everybody know?

Hi,Our UCS C210 M2 is not working. I have intsalled CUCM and Unity Connection in the UCS server. The UCS server is not reachable at all. No Ping or any other connectivity. On physical monitoring, I can see an amber color led on one of the disks. And ...

Hello everyone,I have configured the Nexus speed at 1000 speed. SFP is GLC-T . As you can see below the SFP is model number GLC-T. It is supported on the Nexus 5549UP.Also set duplex to auto on interface but no luck,still getting not connected issue,...

                   Hi,I have to install 2 VSM on two baldes B440 (Full-width) and I need the VMs traffic on these blades to be controlled by the N1K.since cisco recommends not to have the VSM and VEM on the same blade.I thought of creating 2 addition...

Dear Guys...As i am aware aabout UCS server and UCS system..one physicla cpu is equal to virtual cpu...but as i seen many application that having more that 6 cpu need i want to run on one UCS sever...how can adjust the cpu for them?As i have given th...

We followed the Cisco CVD on Vmware and the IP protocol, but we are having problems. The blade initiator does not log into the target igroup (this is on a Netapp controller). No lun is seen at blade bootup. The lun is created, mapped to an igroup and...

I am looking to define an explicit failover order for all dvportgroups created from within vcloud director 5.1 as to control traffic flow across cisco UCS fabric interconnects. Is there a way to set the defaults at the dvswitch level so all created d...

All,UCSPE based on UCSM 2.1 has been released and is available for download http://developer.cisco.com/web/unifiedcomputing/ucsemulatordownload New Features in this release are as below.Release 2.1(1aPE1) adds support for the following: •Cluster  su...