Change UCS 5108 Power Policy from N + 1 to Grid

[vulatec89]

Hello, we have a UCS 5108 chassis with 4 power supplies installed and properly connected to the electrical source as follows:

Power Supply 1 and Power Supply 2 connected to circuit A

Power Supply 3 and Power Supply 4 connected to circuit B

Due to an error, the power policy was set to N + 1 and the chassis was released in production.

Now we want to change that setting to set it to GRID mode.

Is that change in configuration from N + 1 to Grid disruptive?

Thanks for the help you can give me on the subject.

[Wes Austin · Accepted solution]

This change should not be disruptive, however, we always recommend changes during scheduled maintenance windows as a best practice.

[vulatec89]

Thanks for your help and for your advice.