07-22-2015 04:07 AM - edited 03-01-2019 12:17 PM
I have the following errors in the discover the server UCS B440 M2 in the chasis UCS 5180 the firmware is 2.1(1f)
FSM
FSM Status: In Progress
Description:
Current FSM Name: Discover
Completed at:
Progress Status: 9%
Remote Invocation Result: End Point Protocol Error
Remote Invocation Error Code:1002
Remote Invocation Description: Unable to change blade power state-MC Error (-20): Management controller cannot or failed in progressing request
Thanks for you help
07-22-2015 12:24 PM
Likely to be a power-on issue "Unable to change blade power state"... open a TAC case to confirm and replace if needed.
-Kenny
07-23-2015 07:05 AM
Try to decommission and re-acknowledge the Blade. If the issue re-occurs a TAC case will need to be opened to replace Mobo
08-29-2022 01:15 AM
Remote Invocation Error Code:1002
This type error always come when we configure the server and we do not found any solution.
09-06-2023 02:03 PM
ANY SOLUTION???
09-06-2023 02:17 PM
This thread is 8 years old. If you have a similar problem, it may be worth while starting a new thread. If your problem is related tot he original error mentioned "Remote Invocation Error Code:1002" then open a TAC case.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide