- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-13-2011 08:03 AM - edited 03-01-2019 09:47 AM
Hi all,
Just getting my feet wet with UCS and have our first system basically setup.
However I have defined 2 NTP servers within UCSM but it doesn't appear to be working. I've been hunting for an equivalent to show ntp status from IOS but so far haven't found one.
Is there a way to check the time sync status? Or would errors be captured in a log anywhere?
Thanks,
Anthony
Solved! Go to Solution.
- Labels:
-
Unified Computing System (UCS)
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-13-2011 06:16 PM
Anthony
The FI's run multiple control planes viz NXOS, local management and UCSM.
UCSM is the sole way to configure the system while the others are read-only.
You can check ntp status from the NXOS plane.
To do that, ssh to the VIP.
connect nxos
At this point you are connected to the NXOS plane and show commands/debugs are applicable.
"show ntp ?" and you will see the options like status and peers.
Thanks
--Manish
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-13-2011 06:16 PM
Anthony
The FI's run multiple control planes viz NXOS, local management and UCSM.
UCSM is the sole way to configure the system while the others are read-only.
You can check ntp status from the NXOS plane.
To do that, ssh to the VIP.
connect nxos
At this point you are connected to the NXOS plane and show commands/debugs are applicable.
"show ntp ?" and you will see the options like status and peers.
Thanks
--Manish
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-27-2011 02:43 AM
Excellent.
Many thanks Manish.
Anthony
