The setup is a 4 UCS Chassis with 8 blade each, to a total of 32 blades. connectivity is like this UCS-MDS-CX44 Clusters created and a set of 4 Clariion SP ports are assined to boot for a given cluster (set of 8 blades).Likewise all 16 array ports ar...
Hi,We're about to upgrade our UCS installation from 1.3 to 1.4 (reason is that we've got new B230 servers and an additional chassis). Our UCS is connected to a Brocade fabric on the SAN side with several NetApps also attached to the SAN-fabric.The Ha...
Hi,We have a number of datacenters within our vCenter installation, and now we are rolling out Nexus 1000v, can anyone advise if there is a restriction on the number of VSM that can be registered to a DC within vCenter?We are aware of the 64 VEM limi...
I was running UCSM 1.3.1c and was notified by security that the web server component had a security vulverability.I upgraded to 1.4.1j and had them rescan and they are still seeing it as being unpatched.Has anyone else had their UCSM scanned for secu...
Hi all,Cisco advise UCS 1.4 supports PVLAN. But i see the following comment about PVLAN in UCS 1.4"UCS extends PVLAN support for non virtualised deployments (without vSwitch ) . ""UCS release 1.4(1) provides support for isolated PVLAN support for phy...
Hi,we are currently having some issues with UCS. We have 6 UCS servers with ESXi 4.1 installed. All of them seem to work fine, except one ESX is loosing Network redundancy one to three times a day for about one minute. It is always the server located...
Very strange issue. I have 5 ESXi servers in UCS. There are also a number of VLANs used for VM servers connected to virtual distribution switches as we use the Palo CNA that are then passed to vSphere server. Everything has been working fine until...
I am trying to install VMWARE ESXi 4.1 on UCS C210-M2 but there is some problem with my RAID Controller or Hard Disk. can someone help me to troubleshoot.Regards,Faheem Ansari
Since setting our UCS Manager to use HTTPS, we get security prompts when opening the KVM manager.After doing some traces, it looks like the KVM manager makes the following HTTP calls:http://fpdownload.adobe.com/pub/swz/crossdomain.xmlhttp://fpdownloa...
Hi,i using port-channel from both fabric interconnect to N7k with 3 cables per Fabric Interconnect.but, my problem is when i creating port-channel, Fabric Interconnect don't support mode ON dan rate-mode share in Interface 10G Nexus 7010.I was trying...
Hi All,I need some information on Service Profile configuration for ESXi hosts that will be running Cisco Unified Communications Manager and associated applications (Unity Connections and Presence)The B-Series Chassis will initially host 2 B200M2 bla...
Hello,I have installed UCS C series server and able to access CIMC. But, when I try to install ESXi vsphere, I am not able to launch virtual media from Virtual KVM console. On the console, I have this error message. Can anyone explain how to fix this...
Are there any known issues with a Q-Logic adapter after upgrading to 1.3(1p)?I just upgraded UCS firmware to 1.3(1p) from 1.3(1c) and I cannot create 2 vHBAs. I get the config-failure and error is clear, not enough vHBA'sWhen I delete one vHBA profi...
