How to view pre-installed License file

[harrygranger]

Hi,

I was told we that 6296 comes with pre-installed 18-port license but I could find any.

There is nothing under installed license. All I can find is 180 days grace period.

Is pre-installed 18-port license viewable via license management?

Thanks,

Harry

[padramas]

Hello Harry,

You can view default license  ( port count ) by

scope license

show usage

We cannot view the default license file.

http://www.cisco.com/en/US/docs/unified_computing/ucs/sw/gui/config/guide/2.0/b_UCSM_GUI_Configuration_Guide_2_0_chapter_01101.html#concept_02B3BE130EA54738A97CB23D97198B78

HTH

Padma

[pieteryts]

Hi,

No, you cannot view your default license. you can only view additional license as well the grace license (180 days).

you can configure the port normally and the base license should cover up until the certain port number, before start using the grace license.

And the additional Modular also give you another base port license (another 8 port if I'm not mistaken), but you can use it in any port, not only on the module. when you unplug the module, the license is removed, and if the port is greater than the licensed, it will go to the grace license.

Hope it helped.

Thanks,

Pieter

[harrygranger]

Thank you both Pieter and Padma.