what is the appropriate no of nics or best practice setup for nexus 1000k deployment? 2 nics? I currently use 8 vnics split up into 4 vswitches. If i use my current setup, that mean I will need 4 n1k installations?thanks
I'm looking at the UCS Central documentation for the first time because I'm interested in setting it up. I see that it only comes in the form of a virtual appliance. Reading the documentation it says not to put the UCS Central virtual machine withi...
I have a pair of Fabric Interconnects running 2.0(3a). They are clusterd and everything from the clustering point of view and the functionality of the UCSM seems fine. However FI-B doesn't repond to ping or ssh on its management even though the IP se...
Hello,I'm working with C-200-M1 server that have 1 FCoE Qlogic CNA. I've just installed ESX 4.0 Update 1, but I'm not shure if ESX has recognized the Qlogic CNA as a Storage Adapter or only as a Network Adapter.I've attached some screenshots. I'll be...
I seem to keep getting an error about SRIOV bios policy settings, or 'cannot derive mac address from virtual port' when i follow guides for setting up VM-FEX for ucsm and vmware 5.1.Are there any fully-featured guides that go through more than just ...
Hello,When booting from SAN in UCS, what's the best practice when creating the Storage Groups in the disk array?For instance, VMware: is it best-practice to have one storage group for each ESXi and add its own ESXi Boot LUN (id=0) plus the VM datasto...
Hi all,In the design guide when you setup the vswitch you only specify one network adapter for the vswitch. I added a second one in failover and reversed them depending on the order of the Vnics.Is this correct or should I put it back to one?I don't...
Good afternoon folks,As per the upgrade BIOS procedure of C-Series C-200 M1. I am getting an error provided below:Please help me how to upgrade this and move forward.thank you,AK G
I got 3 esxi 5.1 servers setup each with 2 vmk nics - vmk1, vmk2vmk1 is on fabAvmk2 is on fabBthe chassis is connected to the FI, and from the FI, its going directly to the nexus 7k core. Jumbo frames is enabled on the core switches. I have CoS of Go...
Good time of day for everyone!I need length, width and height for Trusted Platform Module box (part number "UCSX-TPM1-001=").Did anyone know this parameters?Big thanks for answer, Andrey.
Hey all,Upgraded my system to 2.1 yesterday. Lost connectovity to the SAN. I see that my FC trunks are in a failed state. My upstream devices are a pair of MDS 9124 running code 4.1(3a).Here is the config that was woring on my switch before the upgra...
