03-23-2016 03:18 AM - edited 03-04-2019 02:26 AM
Hi Everyone,
Hope you are all doing good.
My Question is that if we have associate a service profile with a blade-1 on a chassis and we have some other servers as well on the same chassis let say Blade-2 and Blade-3 which has the same specs as Blade-1 but they are not in use by any service profile in UCS Manager. In UCS Manager can we make any kind of automation, if Blade-1 would fail so the service profile that was associated on that blade will automatically disassociate and re-associate itself with the next available server in the UCS Manager?
Is it possible to do this or not?
Thank you so much in advance.
Best Regards
Muhammad Hasan
03-23-2016 04:25 AM
Hi Muhammad,
It appears that automatic failover of SP to another blade is still not supported. You can check the following post for similar query , it is a bit old but still applies
https://supportforums.cisco.com/discussion/11094066/service-profile-failover
Manish
03-23-2016 06:05 AM
correct! it is still valid, we do not support that kind of failover... you also may end up not knowing where your server is...
-Kenny
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide