I configured it correcly I believe. The strange thing is that there is only one iSCSi initiator pool. See attachment.
so when we configure iSCSi Boot Parameters, there is just ONE IP Address Policy. I think this may be the reason things got messed up in my setup.
Both my two blades are connected SP through FI-A.
The problem is that :
Blade1:
iSCSi-vNIC-A gets initiator IP from FI-B VLAN (the second pool in the attachment) and this is wrong. Should be from FI-A vlan.
iSCS-VNIC-B getsinitiator IP in the FI-B vlan and that is correct.
Fo rBlade 2 something similar happened:
iSCSi-vNIC-A: initiator IP is on FI-A vlan and this is how it should be.
iSCSi-vNIC-B: Wrong initiator IP (FI-A vlan).
All target IPs are correct as I set them to be.
