login vnic shows blank no info

Dragomir · ‎03-11-2013

when I do this following on my FI, I am getting no info at all

connect adapter 1/3/1

connect

attach-fls

adapter 1/2/1 (fls):2# vnic

---- ---- ---- ------- -------

vnic ecpu type state lif

---- ---- ---- ------- -------

23 1 fc active 12

24 2 fc active 13

login 23

any idea why?

dfilenko · ‎03-12-2013

After HBA driver is loaded, all login info from OptioRom is removed.

I prefer to use "lunlist" as it gives more complete output:

adapter 1/1/1 (fls):44# lunlist

vnic : 8 lifid: 5

- FLOGI State : flogi est (fc_id 0x710043)

- PLOGI Sessions

- WWNN 50:0a:09:83:87:09:80:22 WWPN 50:0a:09:83:87:09:80:22 fc_id 0x440001

- LUN's configured (SCSI Type, Version, Vendor, Serial No.)

LUN ID : 0x0000000000000000 (0x0, 0x4, NETAPP , 1ka08?CAlMVw)

- REPORT LUNs Query Response

LUN ID : 0x0000000000000000

LUN ID : 0x0001000000000000

- Nameserver Query Response

- WWPN : 50:0a:09:81:87:09:80:22

- WWPN : 50:0a:09:83:87:09:80:22

- WWPN : 50:0a:09:83:97:09:80:22

- WWPN : 50:0a:09:81:97:09:80:22

Dragomir · ‎03-13-2013

lunlist does not show anything either. lunmap shows

adapter 1/1/1 (fls):7# lunmap

lunmapid: 0 port_cnt: 1

lif_id: 12

PORTNAME NODENAME LUN PLOGI

50:06:01:61:39:a0:16:45 00:00:00:00:00:00:00:00 0000000000000000 N

lunmapid: 1 port_cnt: 1

lif_id: 12

PORTNAME NODENAME LUN PLOGI

50:06:01:63:39:a0:16:45 00:00:00:00:00:00:00:00 0000000000000000 N

lunmapid: 0 port_cnt: 1

lif_id: 13

PORTNAME NODENAME LUN PLOGI

50:06:01:60:39:a0:16:45 00:00:00:00:00:00:00:00 0000000000000000 N

lunmapid: 1 port_cnt: 1

lif_id: 13

PORTNAME NODENAME LUN PLOGI

50:06:01:62:39:a0:16:45 00:00:00:00:00:00:00:00 0000000000000000 N

dfilenko · ‎03-13-2013

Hi Tony,

It's possible that you have more than one adapter in this blade and HBAs are on second adapter, so try to attach to second adapter (1/1/2).

These fields will only populate when blade is attaching to LUN upon reboot (you will see it if quiet boot is disabled).

After OS HBA driver loads, login information is erased.

Dragomir · ‎03-13-2013

the host is booted up. Not in bios. There is an os installed on it. Is that why no info is shown?

thank you