cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1246
Views
5
Helpful
1
Replies

Migrate RAID from UCS server to new RMA server

CDShriver
Level 1
Level 1

Hello,

We have a Cisco UCS C240 M4 that is going through the RMA process.  They are sending out a new chassis due to a motherboard issue and we expect to be able to migrate over from the old server to the new server without losing data.

I'm assuming that the process will be along the lines of physically moving the RAID card and all drives to the new server but I want to make sure that I don't run into problems.  

Is anyone aware of documentation to outline this, or aware of the exact steps that I must follow?

Any help is appreciated!

Thanks!

 

 

1 Accepted Solution

Accepted Solutions

Wes Austin
Cisco Employee
Cisco Employee

Here ya go:

 

Restoring RAID Configuration After Replacing a RAID Controller

 

The new MRAID12G you pretty much just move everything over and the metadata on the drives is read by the controller and the disk groups will re-appear after replacement.

 

Good luck.

View solution in original post

1 Reply 1

Wes Austin
Cisco Employee
Cisco Employee

Here ya go:

 

Restoring RAID Configuration After Replacing a RAID Controller

 

The new MRAID12G you pretty much just move everything over and the metadata on the drives is read by the controller and the disk groups will re-appear after replacement.

 

Good luck.

Review Cisco Networking for a $25 gift card

Review Cisco Networking for a $25 gift card