N20-C6508 UCS 5108 Blade Svr AC Chassis/0 PSU/8 fans/0 fabric e

[alisakhi029]

I have Cisco UCS 5108 and trying to install Cisco UCS 6324 Fabric Interconnect for the configuration purposes. I can't boot it normally. it's give ma message of non-supported.

 

[Wes Austin · Accepted solution]

UCS mini (6324) requires the 5108-AC2 chassis.

https://www.cisco.com/c/dam/en/us/products/collateral/servers-unified-computing/ucs-6300-series-fabric-interconnects/6324-spec-sheet.pdf 

[alisakhi029]

Hi Wes Austin, Thank you for the rapid response. Appreciate it. Could you also guide me if I don't have 5108-AC2, what would be other option to run the 5108 UCS along with M4 blades?

Thanks & regards,  

[Wes Austin]

You would need a UCS Fabric Interconnect 6100, 6200, 6332* or 6400 model with appropriate firmware to support the B200-M4s. 

[alisakhi029]

Hi Austin, 

I managed to run Cisco mini UCS on 5108-AC2 chassis. However, when I assigned an IP address to the Mgmt, It doesn't open the GUI interface. could you please guide?

[Wes Austin]

You can probably access the UCSM setup using HTTP (http://10.10.2.8) instead of HTTPS. Otherwise, just setup UCS from the CLI.