Does enabling hyperthreading needs to be done in the bios? are there instructions on how to do this
Forum Posts
We are currently using hx-m5, and we need to disable ssh due to security issues. What are the things that could be a problem?
Dear experts,I am trying to find an answer to the following question: i have my fabric interconnect configured with both FC and FCoE uplink with a same VSAN. If my server will perform a Boot from SAN, is there any preference algorithm from FI point o...
Resolved! UCS-Fabric Interconnect
Is Fabric Interconnect an FCOE Switch?
We have six nodes of HyperFlex M6 connected to two 6454 FIs. The FIs are connected to a Nexus Switch, but the problem is that we only have one uplink on each FI instead of the required two. Our technician keeps insisting that this is totally fine and...
Hello guys,I'm trying to configure UCS-C240-M7 server in Cisco ccw. I'm getting the following error after configuring, Please note that this product may not be purchased outside of the approved bundles. Please use MLB: UCS-M7-MLB. (CE202322)When I lo...
Hi all:A final customer is asking for help with their UCS C-240M3S. We are using a windows 10 (64bit) laptop with- 32 bits palemoon-32 bits java 1.6_-32 bits java 1.7u80 (jre).The GUI logon on CIMC works fine (yeap that flash thing works!) but every ...
I'm in the process of planning a migration of a pair of 6296's to 64108s and am trying to clarify a few points from the migration guide that Cisco has published for this process.The intention with the hardware upgrade process will be to:put the Sub. ...
Can a UCS chassis be connected to more than one UCS domain or pair of FIs? I need this because I want to migrate from old FI to NEw FIs but reuse the old chassis.
Hi all. Very simple question, I am getting mixed messages about the above? I can't see any where from the GUI or CLI commands to replace the HX Connect self-signed certificate with a customer signed one? Has anyone done it, or knows if it can be don...
we have four blades that we want to add vHBA adapters. The blades are currently associated to service profiles. withing these service profiles i can see a reference to a single vNIC/vHBA placement policy. <<<---- How do i edit this placement policy ...
Anyone use the HCL cmdlets in PowerTool? Wondering when this will be fixed - for a long time, queries to the HCL tool via Powershell incorrectly return 'unsupported' results on C series servers. ie: Add-UcsHardwareProfile: {"ErrorCode":"HP00015","E...
Hi,I was handed a Cisco C240 M6 server to install Ubuntu on. The server is unmanaged and standalone. So I am looking for information on what I need to do to accomplish this. I looked on the Cisco site under this server and "Related Documentation" but...
Resolved! Basic Question about C-Series disks
I am trying to spec out a C-series rackmount with local storage. I would like to have a large RAID-6 volume with 8 drives, but I would also like a smaller Raid-1 mirrored disk with 2 drives for the C: drive of the server. When looking at specs, it ...
Hi Team, I wonder to ask , can the FIs cross connect to FC SAN SW(broadcom)? why or why not? My ucs is FI-6454. Thank you.
