Connect your UCS as follows:
FI-A L1 -> FI-B L1 using cat5/6 (as short or as long as you want. We used a half foot cable)
FI-A L2 -> FI-B L2 using cat5/6 (as short or as long as you want. We used a half foot cable)
FI-A and FI-B management is cat5/6 to a management network switch. Use however long of a cable you will need.
FI to core, depends on your situation. You can get TwinAx that is 10m (30ft) if that's long enough to connect to your core, and your core supports the TwinAx SR. However in my case it isn't long enough. Our UCS came with two 10Gbps Optical SRs. We are using two uplinks from each FI and one goes to 5k-1 and the other to 5k-2.
General summary would be: short run of 10Gbps between cisco devices, use TwinAx. Longer run, use optical SR with fiber cable between the devices. All management/cluster cables are standard cat5/6 Ethernet cables.