When trying to connect a vpc from a nexus 5548up to a UCS FI I get this error. Any suggestions ?
(config-if)# sh vpc consistency-parameters vpc 20
Legend:
Type 1 : vPC will be suspended in case of mismatch
Name Type Local Value Peer Value
------------- ---- ---------------------- -----------------------
Shut Lan 1 No No
STP Port Type 1 Edge Trunk Port Edge Trunk Port
STP Port Guard 1 None None
STP MST Simulate PVST 1 Default Default
mode 1 on active
Speed 1 10 Gb/s 10 Gb/s
Duplex 1 full full
Port Mode 1 trunk trunk
Native Vlan 1 1 1
MTU 1 1500 1500
Admin port mode 1
lag-id 1 - [(7f9b,
0-23-4-ee-be-1, 8014,
0, 0), (8000,
54-7f-ee-99-6e-c1, 13,
0, 0)]
Allowed VLANs - 200-204,213,216-219,23 200-204,213,216-219,23
0,232-233,399 0,232-233,399
Local suspended VLANs - 200-204,213,216-219,23 -
0,232-233,399
(config-if)# sh vpc
Legend:
(*) - local vPC is down, forwarding via vPC peer-link
vPC domain id : 1
Peer status : peer adjacency formed ok
vPC keep-alive status : peer is alive
Configuration consistency status : success
Per-vlan consistency status : success
Type-2 consistency status : success
vPC role : primary, operational secondary
Number of vPCs configured : 1
Peer Gateway : Disabled
Dual-active excluded VLANs : -
Graceful Consistency Check : Disabled
Auto-recovery status : Disabled
vPC Peer-link status
---------------------------------------------------------------------
id Port Status Active vlans
-- ---- ------ --------------------------------------------------
1 Po10 up 1
vPC status
----------------------------------------------------------------------------
id Port Status Consistency Reason Active vlans
------ ----------- ------ ----------- -------------------------- -----------
20 Po1 up failed vpc port channel mode -
mismatch
