Hello,
We have a ACI fabric running 1.1.1o. We have a FEX connected and applied a link policy for the 102/1/41-48 to be fixed 100Mb.
Most ports are in use as you can see in the output below.
LEAF2# show interface ethernet 102/1/41-58 brief
--------------------------------------------------------------------------------
Ethernet VLAN Type Mode Status Reason Speed Port
Interface Ch #
--------------------------------------------------------------------------------
Eth102/1/41 65 eth trunk up none 100(D) --
Eth102/1/42 84 eth trunk up none 100(D) --
Eth102/1/43 0 eth trunk down link-failure 100(D) --
Eth102/1/44 82 eth trunk up none 100(D) --
Eth102/1/45 82 eth trunk up none 100(D) --
Eth102/1/46 82 eth trunk up none 100(D) --
Eth102/1/47 0 eth trunk down link-failure 100(D) --
Eth102/1/48 76 eth trunk up none 100(D) --
Ports Eth102/1/43 and Port Eth102/1/47 are both not part of an EPG. Port Eth102/1/47 has been used in an EPG before, port Eth102/1/43 is still unused.
If we look in the fault section in the APIC there is a warning
"topology/pod-1/node-102/sys/phys-[eth102/1/47]/phys
Port is down, reason:notconnect(connected), used by:Discovery"
We don't get the same warning for interface Eth102/1/43, but the port is in the same state. Is this normal behavior?
It looks like the warning only appears after you use a interface once and then you have to manually disable it to not affect the Fabric Health anymore. Any suggestions?
thanks!
Michel van Kessel
