Hi all!
Sorry if this is not the correct location for this post.
I can ssh to an FI and get the port stats like this:
show interface fc1/30
I am specifically looking for 1 min input and output rates as shown in the show interface output:
1 minute input rate 936866512 bits/sec, 117108314 bytes/sec, 62981 frames/sec
1 minute output rate 181196392 bits/sec, 22649549 bytes/sec, 16698 frames/sec
Ultimately, I would like to store these values and plot them in Grafana.
I cannot determine how to get this info from Powertool, which would seem to be a much better solution. Any advice is appreciated!