Re-Install HX installer , Destroy existing cluster and re-config.

[andyblada1]

Hello Experts,

I need your help in re-config HX Platform. Situation is, I have to perform POC of Hyperflex but initial configuration has been performed by CISCO. Now i want to destroy everything, except VCSA & FI configuration.

What steps i have to perform and from where i have to start.

Setup info :

HXDP Version 3.0(1e)
3 X HXAF220C-M4S nodes.

Cheers!

Andy.

[mojafri]

Hi Andy,

Here you go- http://cisco.box.com/v/hx-cleanup . If this is for POC and you are partner there is separate guide which cannot be shared publicly. You may reach out Cisco TAC to perform full cleanup. 

This guide will not completely remove all HX components from the nodes, just reset the system, which will help you to reinstall HX. 

Please rate if you find it helpful.

Regards,

MJ 

[can.karahaliloglu]

Hello Could you please share HX cleanup tool and procedure to re-install?

Thanks