Unified Computing System Discussions

HiÍ nerd tiverdes my ucs , Wing haver 2 Fiber interconnect . When I finishbreset using reset configurations,  it goes directly to options where said detected peer fiber will b add to the cluster..  I need to reset and start from scratch,  See the att...

I got into a new environment and saw UCS is using nimble storage with ISCSI. but they are using 1500MTU as opposed to 9000. IS is not best practice? how do I check for any dropped iscsi frames?

I got VMs on the same vlan as the pxe/tftp serer but they are not pxe booting. I have the vlans right.  how do I do a packet trace from the vm to the pxe server via the FI?

When will Cisco have a Server system, Cisco UCS, as follows: Dual LGA 3647 4.5 GHz processors with 8 PCIe Generation 4.0 x16 slots? Thank you.

Hey All, I just need to confirm that the Cisco C220 M5SX blades have embedded LSI controller, which hypervisor hides the drives from the ESXi installer? ESXi 5.5.0 (yes i know, environment limited) I have configured the drives in RAID 1, as a bootabl...

Hello team! How are you? I have to configure a server c240-M5 with SMB services as storage to a few server blades in a mini UCS chassis.How would be the procedure/configuration in the ucs to commit this? I attached a topology.Thanks in advance, i was...

I am looking for a list of steps to replace a failed 6248 FI in a 3.1.3a UCSM environment. Got a new 6248 in an RMA from TAC but want to make sure we replace the failed FI with the right steps. Thanks for any guidance.

I need to get all serial number off the Cisco UCS environment (Chassis/blades/stand-alones) so I connected to the UCS Manager using my domain credentials and putty. I am using the command:show chassis inventory expand > FullInventory_2019-05-29 Only ...

We need to connect a UCS C220 server in a FI and reach a network. c220 servers 40gb slot are connected to 6332-16up 40 gb port. If I set the port to network uplink. my vms on other servers got lost connection. maybe because if Netwprk uplink configur...

Hello team, We are unable to install Ubuntu 14 04 on Cisco UCS C240 M5 server which has RAID configuration. RAID Controller Info: RAID bus controller: LSI Logic / Symbios Logic MegaRAID Tri-Mode SAS3516 (rev 01) We are unable to find driver for above...